#	Federal Register
1	11/18/2016 - 1926.500 - 81:82494-83006 - Walking-Working Surfaces and Personal Protective Equipment (Fall Protection Systems) - PDF
2	07/14/1999 - 1926.500 - 64:38077-38086 - Safety Standards for Fall Protection in the Construction Industry. - PDF
3	11/14/1980 - 1926.500 - 45:75618 - Guarding Roof Perimeters - PDF
4	08/17/1979 - 1926.500 - 44:48275-81 - Guarding Roof Perimeters
5	11/16/1972 - 1926.500 - 37:24345 - Guardrails

#	Regulations
1	06/10/2014 - 1926.500 - Scope, application, and definitions applicable to this subpart.

#	Standard Interpretations
1	03/02/2010 - 1926.500, 1926.500(a)(1) - Interpretation of OSHA Fall Protection Exemption (29 CFR 1926.500(a)(1)) during inspection, investigation, and assessment activities.
2	03/02/2010 - 1926.500, 1926.500(a)(2)(iii) - Whether an employer can use a controlled access zone during curtain wall installation.
3	09/05/2006 - 1926.500, 1926.500(b) - When protective measures must be installed after a hole is created on a construction worksite.
4	04/11/2005 - 1926.500, 1926.500(a)(2) - Scaffolding/shoring
5	09/26/2003 - 1926.500 - Compliance of using warning lines and/or control access zones for fall protection on roofs with a slope greater than 4:12.
6	07/07/2003 - 1926.500, 1926.500(a)(2)(i) - Requirements for fall protection when ladder jack scaffolds are used for residential and commercial construction
7	05/21/2003 - 1926.500, 1926.500(a)(2)(vii), 1926.500(b) - Fall protection requirements for an employee working from a ladder on a walking/working surface other than the ground.
8	11/15/2002 - 1926.500 - Fall protection requirements for employees, other than roofers, working on low-slope roofs
9	04/10/2001 - 1926.500 - Requirements of Interim Fall Protection Compliance Guidelines for Residential Construction for guardrails and fall protection during roofing work.
10	08/14/2000 - 1926.500 - Clarification of the terms "hole" versus "unprotected sides or edges."
11	08/14/2000 - 1926.500 - Fall protection for various lift-devices; restraint, positioning, fall arrest and rescue requirements; maintenance vs. construction examples.
12	05/12/2000 - 1926.500 - Fall protection non-conforming guardrail criteria for application of a de minimis policy.
13	09/25/1995 - 1926.500 - OSHA's New Fall Protection Standard for the Construction Industry.
14	09/25/1995 - 1926.500 - OSHA's new fall protection standards for construction will prohibit use of safety belts with side dee rings as part of a personal fall arrest system
15	09/25/1995 - 1926.500 - Review of a new product, "The Safety Boot".
16	08/28/1995 - 1926.500 - The frequency of the load measuring system when testing fall arrest equipment should be set at 500 Hz.
17	03/24/1993 - 1926.500 - Request for approval of guardrail system.
18	10/01/1991 - 1926.500 - Stairways used in construction.
19	09/18/1984 - 1926.500 - Ball-type handrail system.
20	07/24/1984 - 1926.500 - Wire rope and/or cable as a method of perimeter protection for a building under construction.
21	04/14/1981 - 1926.500 - Perimeter guarding of low-pitched roofs.
22	01/09/1979 - 1926.500 - Steel Banding as Guardrails.
23	03/22/1978 - 1926.500 - Requirements for toeboards.
24	10/21/1974 - 1926.500 - Use of stilts.